|
|
|
Product > Mold Release > Non-Silicone Mold Release Formula ER-15
|
|
| |
| NON-SILICONE MOLD RELEASE CARNAUBA WAX |
PRODUCT CODE : ER-15
BRAND NAME : NON-SILICONE MOLD RELEASE CARNAUBA WAX
| DESCRIPTION
Formula ER-15 is a non-silicone mould release agent developed specially for transfer and compression moulding where synthetic thermosetting resins such as phenolic, melamine and epoxy are used. ER-15 is suitable for plastic moulding which requires minimum transfer of releasing agent onto the moulded parts. Due to its dryness it gives to the molded plastic surface, it has excellent paintability to the molded parts and good rust proofing to the metal moulds. ER-15 does not contain any chlorofluorocarbon and ozone depleting substances. It does not contain trichloroethane CAS No: 71-55-6 and dichloromethane CAS No: 75-09-2. The solvent and propellant used are physiologically safe. Net weight per aerosol spray can is 275 gm.
|  | | | Typical Physical & Chemical Properties | | Specific Gravity (250°C) | : 0.67 glee | | Vapor Pressure | : 3.8 kg/cm2 | | Auto ignition temperature | : 357.8°C | | Appearance | : milky wax solution | | Evaporation Rate (d iethyl ether= 1 ) | : 1.5 | | Vapor density (air=1) | : 2.3 | | Flammability | : Flammable (see MSDS) |
| Information on Ingredients | (CAS No) | OSHA PEL-TWA | ACGIH TLV-TWA | | Carnauba Wax (non-hazardous): | 8015-86-9 | | | | Oxygenated Hydrocarbon | 109-87-5 | 1000ppm | 1000ppm | | Liquefied Petroleum Gas | 75-28-5 | | 1000ppm |
| Caution - Shake can frequently during use to avoid any clogging of valve and to give better wax dispersion in solvent.
- Hold can far enough from surface to obtain required spray pattern and coverage.
- Do not over spray but apply evenly and quickly during production.
- For rust proofing of metal moulds, at end of run while the molds are still hot, spray lightly several times to give adequate coverage.
|
April 2004.
| |
|
|
|
Email
to friend 
|
|
| |
|
|
